[Rhodes22-list] CB Pendant Tube Leak

[Karen Fiske / Marc Beroz]

The inside diameter of the tube on my 1984 boat is 5/8". I use the usual
hose clamps on the tube. To tighten the clamp, I use an open end wrench
instead of a screw driver. You can easily do this without cutting any
fiberglass.

Marc

----- Original Message -----
From: "Wally Buck" <tnrhodey@hotmail.com>
To: <rhodes22-list@rhodes22.org>
Sent: Friday, January 10, 2003 9:45 AM
Subject: Re: [Rhodes22-list] CB Pendant Tube Leak


> Bob,
>
> Thanks, I am hoping it will be easy ....and idea of tube size?
>
> Wally
>
>
>
>
>
>
> >From: "Robert Quinn" <rjquinn@bellsouth.net>
> >Reply-To: The Rhodes 22 mail list <rhodes22-list@rhodes22.org>
> >To: "The Rhodes 22 mail list" <rhodes22-list@rhodes22.org>
> >Subject: Re: [Rhodes22-list] CB Pendant Tube Leak
> >Date: Thu, 9 Jan 2003 18:56:12 -0500
> >
> >Wally:  Ours is a clear plastic hose/tube.  If you do not need to replace
> >the line, you may be able to tighten it up without too much work. Just
> >remove the board that holds the fuse panel (may not even have to take it
> >off, just loosen enough to get your hand in to feel along the tube).  See
> >if
> >there is a clamp at the top end.  If not, you may be able to slip one on.
> >The hoses get hard over time and probably need to be replaced.
> >
> >Bob on the "NoKaOi"
> >
> >
> >_________________________________________________
> >Use Rhodes22-list@rhodes22.org, Help? www.rhodes22.org/listBob,
>
>
>
>
> _________________________________________________________________
> MSN 8: advanced junk mail protection and 2 months FREE*.
> http://join.msn.com/?page=features/junkmail
>
> _________________________________________________
> Use Rhodes22-list@rhodes22.org, Help? www.rhodes22.org/list
>