[Rhodes22-list] Rhodes 22 1982

[Mark Kaynor]

Lloyd,

That's great! Thanks. I'll start putting a spec sheet together. I don't
think Gary (Raven's PO) gave me any running rigging measurements, but I'm
pretty sure I've got some sail measurements for her in the file at home -
I'll add them, too.

Anyone else w/ measurements that might be of use to anyone else in our
community - feel free to send them via the list or back channel to me at
mark@kaynor.org. I'll try and get something together next weekend.

Mark Kaynor

----- Original Message -----
From: "lcrowther" <lcrowther@cox.net>
To: "The Rhodes 22 mail list" <rhodes22-list@rhodes22.org>
Sent: Wednesday, January 29, 2003 2:09 PM
Subject: Re: [Rhodes22-list] Rhodes 22 1982


> Mark,
>
> For what it's worth, here is the rigging data I got from the previous
owner
> of my boat, an '84 Rhodes22 with a standard mainsail.  I have replaced
about
> half with line I bought from Sailnet and Defender after my Genoa sheet
began
> to pop out of the clutches and so far the sizes have worked well and I've
> had no more popping.
>
> Lloyd
>
> Rigging Data:
>
> Genoa Sheet - 3/8" - 60'    Black, Spun Braid on Braid
> Furling Line - 3/16"- 1/4" -  3/16" Blue 32', Dacron Yacht Braid
> Main Sheet - 3/8" - 35'    Red, Spun Braid on Braid
> Main Halyard - ¼" -  51'  Red, Spun Braid on Braid
> Center Board Line - ¼"     Red 15' 6", Yale Yacht Braid
> Traveler Line - ¼ - 15'    White, Dacron Yacht Braid
> Backstay Tension Line - ¼" - 15'    Red, Dacron Yacht Braid
> Boom Hold Down Line - ¼" - 4', Dacron Yacht Braid
> Rudder Adjustment    ¼" Black 4'6", Spun Braid
> Jiffy Rigging - ¼" - 12' and 18'   Braided Line
>
> Stays are 1/8"
>
>
> ----- Original Message -----
> From: "Mark Kaynor" <mark@kaynor.org>
> To: "The Rhodes 22 mail list" <rhodes22-list@rhodes22.org>
> Sent: Wednesday, January 29, 2003 11:10 AM
> Subject: Re: [Rhodes22-list] Rhodes 22 1982
>
>
> > This discussion brings up a thought.
> >
> > There's a lot of info in the FAQ, but I looked through it and didn't see
> > anything about sizing running rigging. Not having seen any of the newer
> > manuals (Raven is an '88), I don't know if they contain specs or not.
Most
> > other boats I've looked into have some sort of published specs for sail
> > sizes, rigging, running rigging, etc. Roger has some good info in there,
> but
> > anything relative to mast height is not accurate (at least I assume it's
> not
> > accurate) for those of us w/ IMF.
> >
> > Anyone have good numbers for IMF? Or is the Rhodes custom enough that
one
> > boat's specs wouldn't be appropriate for another boat?
> >
> > I'll be glad to create a specifications doc and post it on the web site
if
> > anyone wants to send me the specifics.
> >
> > Mark Kaynor
> >
> > ----- Original Message -----
> > From: "Bob Weber" <ruba1811@hotmail.com>
> > To: <rhodes22-list@rhodes22.org>
> > Sent: Wednesday, January 29, 2003 10:43 AM
> > Subject: Re: [Rhodes22-list] Rhodes 22 1982
> >
> >
> > > Joseph, congrats on the boat, I am assuming it is new - to you.
> > > 1) halyards are a differnt line than sheets.  If you go to West
Mariine
> > dot
> > > com you will see cordage labled "Halyards".  They are usually smaller
> > gauge
> > > and have a high breaking point and almost no stretch.  The Sheets on
the
> > > other hand, are double braided polyester.  These you want to get as
> large
> > a
> > > gauge that will fit into the Jam cleat ( probably 1/2 inch ).  The
> larger
> > > the size the easier on the hands.  The leangth of each sheet should be
> at
> > 17
> > > to 20 feet a side.
> > >
> > > 2) I dont know if they still make the stove but I have found fuel
> refilles
> > > at Sports Athority.
> > >
> > > 3) For the table leg try a R.V. supply store - they will have one.
> > >
> > > Bob Weber
> > >
> > >
> > >
> > >
> > >
> > >
> > > >From: ComputerEdWorld@aol.com
> > > >Reply-To: The Rhodes 22 mail list <rhodes22-list@rhodes22.org>
> > > >To: rhodes22-list@rhodes22.org
> > > >Subject: [Rhodes22-list] Rhodes 22 1982
> > > >Date: Tue, 28 Jan 2003 19:52:02 EST
> > > >
> > > >Hi All, can anyone please help me with the following queistions for
my
> > > >Rhodes
> > > >22, 1982.
> > > >
> > > >Is 3/8" the right size for the Halyards and sheets. Any Idea how long
> the
> > > >175% genoa sheet is?
> > > >
> > > >I have a Bleuet stove that I need to replace. Are they still being
> > > >manufactured and where?
> > > >
> > > >I need the base to the table support for the main cabin. I went to
West
> > > >marine but no luck. Any Ideas?
> > > >
> > > >Thanks, this is a great site.
> > > >
> > > >Joseph
> > > >
> > > >
> > > >
> > > >_________________________________________________
> > > >Use Rhodes22-list@rhodes22.org, Help? www.rhodes22.org/list
> > >
> > >
> > > _________________________________________________________________
> > > Add photos to your messages with MSN 8. Get 2 months FREE*.
> > > http://join.msn.com/?page=features/featuredemail
> > >
> > > _________________________________________________
> > > Use Rhodes22-list@rhodes22.org, Help? www.rhodes22.org/list
> >
> > _________________________________________________
> > Use Rhodes22-list@rhodes22.org, Help? www.rhodes22.org/list
>
>
> _________________________________________________
> Use Rhodes22-list@rhodes22.org, Help? www.rhodes22.org/list