[Rhodes22-list] Berthing and Sitting Capacity

[Slim]

Rob,

Sorry, no info on Bob H.  But I'd bet that's a standard ablative paint and
I doubt you'd get into much trouble with a little light sanding and a couple
coats of new ablative.

For the table/bed dimensions, There's a little "lip" on the forward edge of
the companionway step and another on the aft edge of the board that swings
down next to the head.  The table rests on those lips.  Measure that
specific length, estimate the width (not critical), round the corners.  A
piece of 3/4" plywood should suffice, or match the thickness of the step to
make the bed match.  Ummm...I just remembered you have a '76 Continental,
right?  It may not have been built with the lips.  Fandango is put away for
the winter so no photos available.

Slim

On 11/21/05 8:10 AM, "Rob Lowe" <rlowe at vt.edu> wrote:

> Slim mentions setting up the table for extra width on the settee.  Our boat
> didn't come with the table and I'd like to build one for next season.
> Anyone gave dimensions, photos, or suggestions?  Thanks
> 
> Rob Lowe
> S/V Getaway
> 
> 
> I usually don't set up the table for the extra width on the settee.  I just
> sleep on it as
> 
> __________________________________________________
> Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list