[Rhodes22-list] Reply to Hank, Mike, Rex - Shroud or Stay Covering

[Philip]

If you roll the wheel while holding the control button down on your computer
you can get a limited zoom.  The gif will become blurry if you zoom too
much, but a little may help you see what you need to see.
Ed, why the three layers?  Wouldn't two or one work?  And why the Teflon and
not just PVC?

Philip


 -----Original Message-----
From: 	rhodes22-list-bounces at rhodes22.org
[mailto:rhodes22-list-bounces at rhodes22.org]  On Behalf Of Tootle
Sent:	Thursday, November 30, 2006 6:03 PM
To:	rhodes22-list at rhodes22.org
Subject:	[Rhodes22-list] Reply  to Hank, Mike, Rex - Shroud or Stay Covering


Folks,

     That is the best picture that I have.  I cannot take a picture now
because I have it in pieces in a storage facility awaiting a scrubbing.  The
original picture was not take to document the set up.  When I put it
together, I was following the directions of another Rhodie and it may have
been as far back as the old sail net list.

       I can only recall the sheet raising the plastic pipe one time.  Yes
it can happen, but does not happen often enough to be noticed.  I have
Stan's thick Marlow or maybe New England Line sheets and they do not catch
the seam to raise it often enough to notice.  But it does roll.

        I do not recall that Rummy's thick sheets are significantly thicker
than my royal blue sheets.  I have seen many boats with thinner sheets.
Maybe fatter sheets are a factor.

         Regarding the Barbe Hauler discussion, as Slim has said, some boats
have a inner rail, maybe that is what the inner track is for?

Ed K
Greenville, SC, USA


Hank-5 wrote:
>
> Ed,
>
> I'd love to see your set up, but my magnifying glass isn't stong enough.
> Any chance you have a higher resolution picture?
>
> Thanks,
>
> Hank
>
> On 11/30/06, Tootle <ekroposki at charter.net> wrote:
>>
>>
>>      Rigging tape or heat shrink keep bare metal from rubbing or chafing
>> the
>> sails or sheets.  However, plastic pipe used for sink plumbing cut to
>> lengths to cover the chain plates and turnbuckles can turn (rotate on a
>> horizontal axis).  That allows for free movement of sheets and
>> sails.  Since
>> the sails are rolling and not rubbing it makes for even less chafing.
>> Get
>> out your magnifying glass and see the attached picture from the archives:
>>
>>
>>
http://www.rhodes22.org/pipermail/rhodes22-list/attch/200509/30/shroudcovers
.gif
>>
>>      Note that the bottom piece is flush with the deck and rotates free
>> and
>> independent of the next two pieces above.  Each of the three layers
>> rotates
>> and rotates independently.  The total weight for all the pieces for four
>> stays is maybe a quarter of a pound.  Small amount of weight for saving
>> your
>> sails.  Available from Lowes, Home Depot or your local Ace Hardware.
>> Note
>> that the top thin piece is not pvc but teflon tube(or other slick
>> plastic)
>> that just fits over the screw part of the turnbuckle when saparated from
>> the
>> turning part of the turnbuckle.  It is a four foot piece and in addition
>> to
>> turning freely is slick.
>>
>>
>> Ed K
>> Greenville, SC, USA
>> Also:
>>
>>
http://www.rhodes22.org/pipermail/rhodes22-list/attch/200605/22/shroudcover2
.gif
>>
>>
>>
>>
>>
>> --
>> View this message in context:
>> http://www.nabble.com/Shroud-or-Stay-Covering-tf2733269.html#a7624374
>> Sent from the Rhodes 22 mailing list archive at Nabble.com.
>>
>> __________________________________________________
>> Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list
>>
> __________________________________________________
> Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list
>
>

--
View this message in context:
http://www.nabble.com/Shroud-or-Stay-Covering-tf2733269.html#a7629993
Sent from the Rhodes 22 mailing list archive at Nabble.com.

__________________________________________________
Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list