[Rhodes22-list] Stainless Steel Cutting Question

[Dave Bradley]

I'll take a look when i get home.   It was probably a simple carbide grinding wheel.  Was cutting 16 penny nails if I recall correctly.   


-----Original Message-----
From: Brad Haslett <flybrad at gmail.com>
Sent: Saturday, August 16, 2008 3:01 PM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Stainless Steel Cutting Question

Dave,

Did you use the carbide or diamond wheel or "just a wheel".  I need to buy a
small piece of stainless sheeting for practice and to make the scab patch
with.  I'd like to avoid buying a $20 wheel if it isn't going to hack the
job.

Brad

On Sat, Aug 16, 2008 at 4:55 PM, Dave Bradley <dwbrad at gmail.com> wrote:

> Brad, I've cut thicker steel with the grinder wheel attachment to my Dremel
> tool.  Though not that long a cut.
>
> Dave
>
>
> -----Original Message-----
> From: Brad Haslett <flybrad at gmail.com>
> Sent: Saturday, August 16, 2008 2:30 PM
> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
> Subject: [Rhodes22-list] Stainless Steel Cutting Question
>
> Dear Rhodies,
>
> I need to cut an inspection panel about 1" x 4" in a stainless steel duct


[The entire original message is not included]