[Rhodes22-list] Chainplate reinstallation

[Lowe, Rob]

That is indeed another option.  My cabin roof wood was rotted and I went the cabin sidewall route.  I'll post a picture of my cabin top access hole tomorrow. - rob
________________________________________
From: rhodes22-list-bounces at rhodes22.org [rhodes22-list-bounces at rhodes22.org] On Behalf Of Ronald Lipton [ronald.lipton at gmail.com]
Sent: Thursday, September 01, 2011 10:38 AM
To: The Rhodes 22 Email List
Subject: Re: [Rhodes22-list] Chainplate reinstallation

One word of caution.  I rebedded my aft lower chainplate a couple of years ago.
I expected the chainplate to go straight down along the cabin wall so I drilled a hole
in the cabin liner - no chainplate.  It turns out that the chainplate is bent by 90
degrees and bedded under the plywood spacer.  I replaced the rotted wood and
epoxyed around the chainplate.

Ron

On 9/1/11 8:13 AM, Lowe, Rob wrote:
> I used a backing block is just a piece of 1X4, just something to hold the screws.  I used machine screws with nuts.  But again I used nylon since I wanted a break away function.  Now that I look closely at what Slim did, he might have used sheet metal screws on both sides to provide the same ability.  I don't think you want a strong though bolt that won't give should another serious problem occur.  If you're discussing with Stan, might see what he recommended.  Or maybe Slim will chime in. - rob
>
>
> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list
>
> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list
> __________________________________________________

__________________________________________________
To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list
__________________________________________________