[Rhodes22-list] Center Board leak

[Michael D. Weisner]

I always had to use 3M 4200 on the seal on my '81.  I too had a problem with
just the gasket - lots of leaks!  Maybe there was a problem with the form
that was used to make the CB trunk & cap in those days.

Mike
s/v <-- NoName -->  ('91)
Nissequogue River, NY



-----Original Message-----
From: rhodes22-list-bounces at rhodes22.org
[mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of rbeytagh
Sent: Wednesday, September 18, 2013 1:24 PM
To: rhodes22-list at rhodes22.org
Subject: [Rhodes22-list] Center Board leak

Wow....I just splashed my boat for the first time simply to see if the new
center board gasket I installed  was water proof. It wasn't....water poured
in as if there was nothing there. I tightened all the screws but this only
slowed down the in-flow a little. Stan is adamant that no silicon should be
used to seal the gasket, but apart from this I can't figure a way to seal
this. Any suggestions?

Thanks
Richard - S/V Waif
Asheville NC 



--
View this message in context:
http://rhodes-22.1065344.n5.nabble.com/Center-Board-leak-tp46798.html
Sent from the Rhodes 22 mailing list archive at Nabble.com.
__________________________________________________
To subscribe/unsubscribe go to
http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list Charter and help with using the mailing list and archives go to
http://www.rhodes22.org/list
__________________________________________________