[Rhodes22-list] Converting Electric Winch Motor Lift to a Manual System

Tom Van Heule tom.vanheule at intrinsicprograms.com
Sat Sep 5 17:44:34 EDT 2020


I'm wondering if there is space for another set of blocks to get another
purchase or two? That's seems most obvious way to reduce the effort?

On Sat, Sep 5, 2020, 4:37 PM Peter Nyberg <peter at sunnybeeches.com> wrote:

> George,
>
> Actually, I have the Mercury 8 HP, only 90-something lbs.
>
> Yes, I also have 4 double blocks.  Obviously there’s some friction in the
> blocks themselves, plus the line turning on the stainless tube.  Also some
> friction in the aluminum slides.
>
> I’ve tried some alternative line routes that made the situation worse, but
> none that have improved it noticeably.
>
> —Peter
>
>
> > On Sep 5, 2020, at 5:22 PM, Gmorganflier <gmorgan.flier at gmail.com>
> wrote:
> >
> > Peter,
> >
> > I believe you and I have the same 9.9 Mercury motor weighing 106 lbs.
> >
> > I just took some bathroom scales out to my boat and weighed myself and
> then
> > tried to get a reading while pulling the engine up. If it was anywhere
> near
> > being accurate, it seemed to average around 40-45 lbs until the engine
> > starts to tilt, and then it’s quite a bit more.(couldn’t measure it with
> the
> > bathroom scale method)
> >
> > Is your system also a 9/1 ratio...4 double blocks?
> >
> > I wonder why the pull is so much more than we expected?
> >
> > George
> >
> >
> >
> > --
> > Sent from: http://rhodes-22.1065344.n5.nabble.com/
>
>


More information about the Rhodes22-list mailing list