[Rhodes22-list] In-hull transducer?

[Bob Garrant]

Thanks John,
that sounds very encouraging.
Bob

On Mon, Jul 25, 2022 at 4:07 PM John Keyser <retro53 at msn.com> wrote:

> Hi Bob,
> I put one in my boat at the same approximate place. No thru-hull
> installation. Just epoxied it to the inside of the hull following the
> manufacturers instructions. Works fine - no issues.
> Good luck!
> John Keyser
> "Deci-Belle"
> Philadelphia, Pa
> ________________________________
> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of Bob
> Garrant <bgarrant at gmail.com>
> Sent: Monday, July 25, 2022 2:23 PM
> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
> Subject: [Rhodes22-list] In-hull transducer?
>
> Hi folks,
> I am installing an in-hull transducer.
> I’m trying to figure out where to locate it. Thinking about placing it
> below the cabin floor just offset from the centerboard sleeve.
> Wondering if anyone in the group has installed an in-hill transducer and
> how it was done.
> Thanks very much
> Bob Garrant
> Sail la Vie
> Kent Island, MD
>