[Rhodes22-list] Size of Centerboard hole

[mm.bizlist1 at gmail.com]

Joe, where would we find Stan's instructions?

Thanks,

Mike McKay
s/v Liber (2006/2018)
Allatoona Lake
Acworth, GA



-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of Joe Dempsey
Sent: Saturday, May 14, 2022 5:40 PM
To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>; 'ROGER PIHLAJA' <roger_pihlaja at msn.com>
Subject: Re: [Rhodes22-list] Size of Centerboard hole

By the way, when it comes to replacing the cap and gasket, Stan has very specific instructions. There are 50+ 316 SS Machine screws and fender washers  and backing nuts securing the rubber gasket. It does not require sealant. If properly fastened and the machine screws carefully tightened, it will remain water tight. Do not over tighten! If you cannot find Stan's instructions, let me know and I will post them.

Joe Dempsey
SV Respite
Deltaville, VA

-----Original Message-----
From: Joe Dempsey <jpd9668 at gmail.com> 
Sent: Saturday, May 14, 2022 5:24 PM
To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>; 'ROGER PIHLAJA' <roger_pihlaja at msn.com>
Subject: RE: [Rhodes22-list] Size of Centerboard hole

Photos I left off earlier post!


-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of chuy carreon
Sent: Saturday, May 14, 2022 12:02 PM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>; ROGER PIHLAJA <roger_pihlaja at msn.com>
Subject: Re: [Rhodes22-list] Size of Centerboard hole

Thanks Roger. The pivot hole was the hole that I was referring to.

Chuy Carreon
S/V AfterMath

> On May 14, 2022 at 9:32 AM ROGER PIHLAJA <roger_pihlaja at msn.com mailto:roger_pihlaja at msn.com > wrote:
> 
> 
>     Unfortunately, there are also 2 holes in the centerboard. There is a hole which is a snug fit with a 1/2” OD shoulder bolt which is what the centerboard pivots on. Then, there is another hole near the trailing edge of the centerboard for the pennant. On my boat, this hole is 3/8” ID.
> 
>     Roger Pihlaja
>     S/V Dynamic Equilibrium
> 
> 
>     Sent from my iPhone
> 
>         > > On May 13, 2022, at 9:08 PM, Graham Stewart <gstewart8 at cogeco.ca mailto:gstewart8 at cogeco.ca > wrote:
> > 
> >         Hi
> > 
> >     > 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Bilge-CB Trunk After.jpg
Type: image/jpeg
Size: 3490054 bytes
Desc: not available
URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20220514/0465cf7d/attachment.jpg>