[Rhodes22-list] Trailer winch

Mary Lou Troy mtroy at atlanticbb.net
Wed Nov 18 11:23:58 EST 2026


It is awkward to pull it out incrementally but we were very successful 
doing it that way for the 18 years we owned the R22.

Our method was to pull it forward until there was slack which if pulled 
further would allow the boat to slip back. At that point we paused and 
winched up the slack. We would do this however many times it took to get 
the boat to the right point. We had the bow stop piece marked with some 
paint so we knew exactly where we wanted to boat for the right  tongue 
weight. We found that the process varied somewhat from ramp to ramp but 
we got so used to it that it only took a few minutes longer than if we 
had been able to winch it all the way forward.

Mary Lou

On 11/18/2026 10:34 AM, peter beckerman via Rhodes22-list wrote:
> Thanks to all for your thoughts,    My recovery procedure:    With the trailer in the water to the top of the bunks and the bow crutch slid all the way forward I winch the boat fully to the crutch. Then as I pull the trailer out of the water and the boat settles on the bunks it pivots back too far away from the crutch.  I’m trying to move the hull 6-12 more inches to improve tongue weight.  There’s something in the manual about towing to about 5 mph and slamming on the brakes which I tried unsuccessfully, and I read somewhere (manual?) about using an old tire as a bumper and backing up against a tree which I have not tried (too scared).    As Peter suggested on my next attempt I will probably try pulling the trailer out incrementally and winching as I go.  Seems kinda awkward.
> Does anyone have any other tips?Also is it possible to buy too strong of a winch?AFAIK my winch is original (1986), but I did replace the strap!
> Peter



More information about the Rhodes22-list mailing list