[Rhodes22-list] 1984 Rhodes 22 for sale

Wally Buck tnrhodey at hotmail.com
Thu Dec 16 19:02:04 EST 2004


Wow, what a deal!

Wally

>From: "Karen Fiske / Marc Beroz" <kfiske at erols.com>
>Reply-To: The Rhodes 22 mail list <rhodes22-list at rhodes22.org>
>To: "The Rhodes 22 mail list" <rhodes22-list at rhodes22.org>
>Subject: [Rhodes22-list] 1984 Rhodes 22 for sale
>Date: Thu, 16 Dec 2004 18:46:13 -0500
>
>I am selling my Rhodes 22. The boat is located in Durham, CT. I have some 
>photos at: http://usera.imagecave.com/MarcBeroz/Orion/    . More photos are 
>available if there is anything in particular you'd like to see. The boat 
>has inner-mast furling. Most other features I think you can glean from the 
>list shown below & the photos.  The boat is on a Triad trailor & does not 
>have brakes. I'd like to keep the delta anchor and handheld gps. The anchor 
>storage tube goes with the boat if desired. I can also reinstall the 
>hangers for a danforth anchor along with a danforth. I'm asking $7500. If 
>anyone is interested please e-mail me directly. I usually don't monitor the 
>list but if there is curiosity, I will post responses to my e-mail on the 
>list.
>
>Marc
>
>
>
>
>
>Work done on Orion:
>
>
>
>1999
>
>New boom slider
>
>
>
>2000
>
>New 150 genoa made by Kappa Sails, Westbrook, CT
>
>New CDI FF2 roller furler
>
>Added interior and cockpit 12 volt power receptacles
>
>New jam horn cleats on boom to tie off outhaul & furling line
>
>Tie down for fuel tank
>
>Garhauer low lead genoa blocks
>
>New jam cleats for genoa sheet
>
>New backstays & traveller bar
>
>New VHF coax cable
>
>New pop top slider
>
>
>
>2001
>
>Rebed cabin side ports
>
>Backing plate on bow cleat
>
>Rebed bow chocks
>
>New porta potty
>
>New windex
>
>Replace genoa sheet
>
>New main sail with 2 vertical battens - made by Kappa Sails
>
>New 4 circuit fuse panel
>
>New mahogany hatch sliders
>
>Rebed table socket in cockpit floor
>
>Replaced left rear trailer lite
>
>
>
>2002
>
>Rebed rubrail
>
>Epoxy coat on CB trunk
>
>Delta anchor & storage tube
>
>Replace wire going to steaming light
>
>Run VHF wire & steaming light wire through foam pipe insulation
>
>Install thru-hull for fuel line to outboard
>
>Install tiller tamer
>
>
>New Nissan 8 hp long shaft 2 stroke
>
>
>
>2003
>
>rebuilt outboard motor lift
>
>replaced cleat & mounting block for outboard lift control line
>
>rebed forward ports
>
>changed OB impeller
>
>
>
>2004
>
>rebed chain plates
>
>New cowl
>
>Seal cowl thru deck opening with epoxy
>
>Replace interior pegboard
>
>Rebed bow eye loop
>
>Replace companionway kick plate
>
>New group 27 deep cycle battery
>
>Trailor - replace axle, all lights, nylon strap, chains & hooks
>__________________________________________________
>Use Rhodes22-list at rhodes22.org, Help? www.rhodes22.org/list




More information about the Rhodes22-list mailing list