[Rhodes22-list] Standard Mast PT slider

[Arthur H. Czerwonky]

Thanks, Rob.  Whenever.
Art

-----Original Message-----
>From: "Lowe, Rob" <rlowe at vt.edu>
>Sent: Jul 21, 2008 4:53 PM
>To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
>Subject: Re: [Rhodes22-list] Standard Mast PT slider
>
>Art,
>Forgot to take the camera with me this past weekend.  I'll try again
>this weekend. - rob
>
>
>
>-----Original Message-----
>From: rhodes22-list-bounces at rhodes22.org
>[mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Arthur H.
>Czerwonky
>Sent: Wednesday, July 16, 2008 12:19 PM
>To: The Rhodes 22 Email List
>Subject: Re: [Rhodes22-list] Standard Mast PT slider
>
>Rob,
>Thank you - I'd sure like to see them.  Where are you sailing your boat
>this summer?
>Art
>-----Original Message-----
>>From: "Lowe, Rob" <rlowe at vt.edu>
>>Sent: Jul 16, 2008 11:55 AM
>>To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
>>Subject: [Rhodes22-list] Standard Mast PT slider
>>
>>Art,
>>If you need a photo of a standard mast PT slider, I can take a couple
>>this weekend.  Does Stan have these parts?  Sure would be a lot easier
>>than making one. - rob
>>
>>According to Dwyer, this is the standard mast:
>>http://www.dwyermast.com/items.asp?cat1ID=20&cat1Name=Masts&familyID=40
>&
>>familyName=DM%2D6+Mast
>>
>>they don't seem to have the gooseneck/slider that Stan uses, but the
>>basic configuration is like the D17 and D11 styles shown mid way down
>>this page.  You can see how the slider would fit in the slot of the
>>mast. - rob
>>
>>http://www.dwyermast.com/items.asp?cat1ID=40&cat1Name=Hardware&familyID
>=
>>17&familyName=Goosenecks
>>
>>
>>
>>
>>-----Original Message-----
>>From: rhodes22-list-bounces at rhodes22.org
>>[mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Arthur H.
>>Czerwonky
>>Sent: Wednesday, July 16, 2008 10:40 AM
>>To: The Rhodes 22 Email List
>>Subject: Re: [Rhodes22-list] Mast Boom Car temp pin
>>
>>John,
>>The threading could possibly help, a little snug in the pin hole.  You
>>could lost a smooth surfaced pin, possibly by just by slipping out.
>The
>>length could be estimated by mk1 eyeball.  Do you have a picture of
>your
>>PT slider for your conventional mast?  I may need to remake one myself.
>>Thx,
>>Art
>>
>>
>>__________________________________________________
>>To subscribe/unsubscribe or for help with using the mailing list go to
>http://www.rhodes22.org/list
>>__________________________________________________
>
>__________________________________________________
>To subscribe/unsubscribe or for help with using the mailing list go to
>http://www.rhodes22.org/list
>__________________________________________________
>
>__________________________________________________
>To subscribe/unsubscribe or for help with using the mailing list go to http://www.rhodes22.org/list
>__________________________________________________