[Rhodes22-list] Re design of Rhodes Interior and elimination of compressi...

[cowie]

This discussion has been helpful for me as a new r22 2009 owner.  I hand
tightened my stays and avoided using any tools in order not to over tighten. 
When healed over my leeward stays do have some slack.  would it make sense
to hand tighten the slack stays while healed over?  Or would it be wiser to
take a few extra turns with a tool when the boat is level until the slack
when healed is eliminated?  I also notice that my stays sometimes go slack
over time and suppose I need to secure the turn buckle after hand
tightening.  What is the proper way to secure the stay?  Tape, wire, pins or
some other devise?


Rick-139 wrote:
> 
> ML is right about stay tension not affecting sailing performance with IMF.
> Except the forestay which should be tightened using the aftstay tensioner
> when headed up wind.
> 
> Too tight or too loose does stress the mast step.  Hand tightening takes
> care of that just fine.  Using a Loos guage is cutting butter with a chain
> saw.
> 
> Rick
> 
> On Tue, Jun 2, 2009 at 9:18 PM, Mary Lou Troy <mtroy at atlanticbb.net>
> wrote:
> 
>> At 08:09 PM 6/2/2009, Rummy wrote:
>> >owners who tightened their
>> >stays to the  point that they did significant damage to their hulls. I'm
>> >simply saying that  there is no known statistic for the R22 using the
>> Loos
>> >gauge. Certainly nothing  from General Boats. Common sense wins out on
>> this
>> >topic. Taking nothing away  from Mary Lou.
>>
>> Right. There's a reason I haven't voiced an opinion on this issue.
>>
>> We've had our stays too tight. We've had our stays too loose. We've
>> even used a Loos Gauge.
>>
>> None of it seems to make too much difference in how the boat sails. I
>> suspect too tight contributed to the depression of the compression
>> post. Too loose once left us with a dangling shroud when it managed
>> to gradually unscrew itself - we started using cotter rings on the
>> turnbuckles and now use a bit of monel wire through the hole in the
>> turnbuckle screw and wrapped around the turnbuckle - easier to fasten
>> and unfasten than cotter rings. That might have been Rummy's idea. If
>> you use it make sure the ends of the wire are on the inside of the
>> turnbuckle. I snagged the seat of my pants while adjusting a fender.
>> Oops.
>>
>> Mary Lou
>> 1991 R22 Fretless
>> Rock Hall, MD
>>
>> __________________________________________________
>> To subscribe/unsubscribe or for help with using the mailing list go to
>> http://www.rhodes22.org/list
>> __________________________________________________
>>
> __________________________________________________
> To subscribe/unsubscribe or for help with using the mailing list go to
> http://www.rhodes22.org/list
> __________________________________________________
> 
> 

-- 
View this message in context: http://www.nabble.com/Re%3A-Re-design-of-Rhodes-Interior-and-elimination-of-compressi...-tp23832100p23854466.html
Sent from the Rhodes 22 mailing list archive at Nabble.com.