[Rhodes22-list] Trailer Position

Lowe, Rob rlowe at vt.edu
Tue Sep 11 14:37:15 EDT 2012


All the weight of my boat rests on the bunks.  I don't have any rollers so therefore no weight on them.

As noted, the hull will deflect some from the bunks.  But it's not permanent and doesn't appear to hurt the boat.  My previous boat as a 76 and has spent many a year on a trailer with no ill effects.  My current boats spent three years straight on a trailer with no ill effects.

I would imagine the hull of this boat would handle most anything.

When  I tow my boat, I strap down both the center of the boat with a strap and then strap the bow down also to help prevent it rocking on the trailer.

The most important aspect of trailering is boat placement on the trailer.  You want the boat forward enough to provide sufficient tongue weight.  Too little and the boat will fishtail on you.  

My 2 cents. - rob




-----Original Message-----
From: rhodes22-list-bounces at rhodes22.org [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Jay Curry
Sent: Tuesday, September 11, 2012 1:34 PM
To: Rhodes List
Subject: [Rhodes22-list] Trailer Position

Thanks to those that responded to my earlier message about the boat position on my trailer. The responses were very helpful but I still need to work out some key points. I will start with keel and bow support.

Should the keel support some weight as it sits on the trailer? If so, is the roller adequate to hold the weight, or should some sort of bunk be installed forward of the roller?

My 20 year old keel has a small indentation where it looks as though it rested on the roller on a former trailer. On my trailer the keel rests above the roller and supports no weight.  I think a bunk board arrangement would be best and that the roller may damage the keel finish or be damaged by the weight it might be subjected to. I think the keel needs to support some weight to reduce hull deflection at the trailer posts. My hull is deflecting more than I would like to see. Am I on  track here?

Can the hull handle a bow support roller or cradle?

The winch strap and bow stop are in adequate to prevent the bow from bouncing under tow. A bow support of some kind is needed. I could mount a roller or cradle directly under the deck point where the slope of the cabin roof reaches the fore deck just ahead of the forward looking port windows. I think a cradle would be best since a bow roller might impact and damage the hull at its point of contact.

Any experience you folks could share with the above concerns would be helpful. Most of my use will involve trailering. Some of that trailering will be long distance. The trailer has has to be right and the boat comfortable on it in almost any road condition.

Thanks

__________________________________________________
To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list __________________________________________________



More information about the Rhodes22-list mailing list