[Rhodes22-list] Rudder-Engine Conflicts

[Allyn Baskerville]

Great idea, and I'll likely run with this. Thanks for the info, Dan. Michael, thanks for the link. 

-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of Dan Stricof
Sent: Tuesday, July 14, 2020 12:59 PM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Rudder-Engine Conflicts

I would recommend using a propeller guard, it should solve the problem completely without the need to move your motor mount or other more difficult solutions.  I sometimes launch in shallow water where I cannot put the rudder down all the way, I dinged my rudder a couple of times. To solve this issue, I mounted a propeller guard, a simple and effective way to prevent the prop from damaging the rudder. Attached are two photos of the stainless steel guard, it also helps protect the prop from getting tangled with weeds or fishing lines. I have not noticed any significant negative effect on propulsion. There are several brands available, including Mac's Prop Saver which is sold by West Marine and elsewhere.

Dan Stricof
Leelanau County, Northern Michigan

On Tue, Jul 14, 2020 at 10:50 AM Allyn Baskerville <allynb at adsne.com> wrote:

> I've been intending on getting photos taken since I posted this, and 
> I'm at the boat club several times a week and keep forgetting. The 
> rudder blade is down all the way, and I've tilted the engine and tried 
> everything I can think of to keep them from hitting each other. At 
> best, the prop just barely nicks the edge of the rudder blade as you 
> can see in the one picture where the blade is up (next to the engine). 
> I now rarely motor in and out of my slip (only when solo), so this is 
> less of an issue, but I still need to repair the damage to the rudder. 
> I've not pulled my boat out of the water since March, and I don't have an easy way to measure the distances.
>
>
>
> -----Original Message-----
> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of 
> ROGER PIHLAJA
> Sent: Wednesday, June 10, 2020 12:16 PM
> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
> Subject: Re: [Rhodes22-list] Rudder-Engine Conflicts
>
> Allyn,
>
> Mary Lou Troy is correct.  The rudder blade needs to be all the way 
> down in order to clear the prop.  However, your boat might have another issue.
> Your motor mount might be installed too far inboard.  Or, your rudder 
> might have been installed off the transom centerline to port; but, 
> that seems very unlikely.  Try this: Measure the distance from the 
> rudder's gudgeon centerline to the centerline of the outboard motor 
> mount.  It's pouring cat & dogs right now, so I can't go make that 
> measurement on S/V Dynamic Equilibrium.  But, when the rain lets up, I 
> will go make that measurement and let you know what I find.
>
> Roger Pihlaja
> S/V Dynamic Equilibrium
>
> Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for 
> Windows 10
>
> From: Mary Lou Troy<mailto:mtroy at atlanticbb.net>
> Sent: Wednesday, June 10, 2020 9:27 AM
> To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
> Subject: Re: [Rhodes22-list] Rudder-Engine Conflicts
>
> Is your rudder pulled all the way forward with the control line on the 
> front edge of the rudder? It sails better with it pulled forward too.
>
> Ours was close after we bought a new motor with a larger low-thrust 
> prop but the rudder never came in contact with the prop. Hopefully 
> someone else has had and solved the issue.
>
> Mary Lou
>
> On 6/9/2020 11:38 PM, Allyn Baskerville wrote:
> > Being new to the local boat club, I was assigned a slip that can be 
> > a challenging getting in and out of. I literally have 2' to spare 
> > backing up and none on the port side. I rely on the engine getting 
> > outOf the slip area, though it's not bad pulling back into the slip.
> > The engine doesn't turn with the rudder, and I have to be very 
> > careful or the prop bangs on the rudder. Depending on the wind, I 
> > sometimes have to make some sharp turns.  I need to fix the rudder 
> > due to prop damage, but before doing so, does anyone else have this 
> > problem? Any solutions for dealing with this? Thanks
> >
> > Sent from my iPhone
>
>
> --
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> -------------- next part -------------- A non-text attachment was 
> scrubbed...
> Name: IMG_0576 (1).jpg
> Type: image/jpeg
> Size: 83560 bytes
> Desc: IMG_0576 (1).jpg
> URL: <
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200714/7dfb7
> 556/attachment.jpg
> >
> -------------- next part -------------- A non-text attachment was 
> scrubbed...
> Name: IMG_0577 (1).jpg
> Type: image/jpeg
> Size: 69649 bytes
> Desc: IMG_0577 (1).jpg
> URL: <
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200714/7dfb7
> 556/attachment-0001.jpg
> >
> -------------- next part -------------- A non-text attachment was 
> scrubbed...
> Name: IMG_0578 (1).jpg
> Type: image/jpeg
> Size: 101502 bytes
> Desc: IMG_0578 (1).jpg
> URL: <
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200714/7dfb7
> 556/attachment-0002.jpg
> >
>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: IMG_1401.jpg
Type: image/jpeg
Size: 784216 bytes
Desc: not available
URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20200714/529afbd6/attachment.jpg>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: IMG_1402.jpg
Type: image/jpeg
Size: 549623 bytes
Desc: not available
URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20200714/529afbd6/attachment-0001.jpg>