[Rhodes22-list] Hull Thickness

[Lowe, Rob]

Most of with bilge pumps tie into the sink drain discharge with a T fitting. - Rob


________________________________
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of Graham Stewart <gstewart8 at cogeco.ca>
Sent: Monday, October 4, 2021 8:17 PM
To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Hull Thickness

Normally you would want the thru hull for a bilge pump as high up on the
hull as possible with a loop in the discharge hose. My discharge is above
the galley where the hull is about .25" thich as I recall. Maybe I don't
understand what you are asking.

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario






-----Original Message-----
From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of
Joe Dempsey
Sent: Monday, October 4, 2021 6:11 PM
To: rhodes22-list at rhodes22.org
Subject: [Rhodes22-list] Hull Thickness

I'm looking to mount a small bilge pump in the lazarette of my Rhodes. I'm
having difficulty finding articles in the new Archives. Too many pages to
scroll through and click. I've found a couple of articles indicating the
thickness 12" or more from the centerline. Can anyone tell me the thickness
near the centerline (6" or less)?

 Thanks!