[Rhodes22-list] Trailer winch
Graham Stewart
graham at debgraham.ca
Wed Nov 18 22:01:44 EST 2026
Chris: A picture of how this works would be really useful.
> On Nov 18, 2026, at 8:57 PM, Chris Geankoplis <chrisgeankoplis at gmail.com> wrote:
>
> Keep in mind you should have between 350 and 450 pounds of tongue weight. That way she will tow beautifully on a single axel. You can use a 2x4 with 1’ in front of a fulcrum. So at the 4’ board math it will take about my weight of 175 to begin to lift the chocked trailer I work with a 6’ piece marked off at 4’3” (3” under the tongue and then 1’ to the fulcrum. Haven’t had any problems after towing well over 12,000 miles.
> Chris Geankoplis
> XENOS & Blue boat
> Sent from my iPhone
>
>> On Nov 18, 2026, at 6:49 PM, Graham Stewart <graham at debgraham.ca> wrote:
>>
>> I have always found that I have been unable to to get the boat sufficiently forward. Ontario one occasion the boat started to sway severely. I was very lucky that it occurred on a multi lane highway when there was no traffic.
>> I only tow the boat from my home to the boat launch about 5 miles at low speed so I am not concerned However, should I ever take it on a longer trip I would redistribute weight by moving the motor to the car and moving anything that is heavy like the gas tank forward in the boat.
>>
>>>> On Nov 18, 2026, at 11:24 AM, Mary Lou Troy via Rhodes22-list <rhodes22-list at rhodes22.org> wrote:
>>>
>>> It is awkward to pull it out incrementally but we were very successful doing it that way for the 18 years we owned the R22.
>>>
>>> Our method was to pull it forward until there was slack which if pulled further would allow the boat to slip back. At that point we paused and winched up the slack. We would do this however many times it took to get the boat to the right point. We had the bow stop piece marked with some paint so we knew exactly where we wanted to boat for the right tongue weight. We found that the process varied somewhat from ramp to ramp but we got so used to it that it only took a few minutes longer than if we had been able to winch it all the way forward.
>>>
>>> Mary Lou
>>>
>>>>> On 11/18/2026 10:34 AM, peter beckerman via Rhodes22-list wrote:
>>>> Thanks to all for your thoughts, My recovery procedure: With the trailer in the water to the top of the bunks and the bow crutch slid all the way forward I winch the boat fully to the crutch. Then as I pull the trailer out of the water and the boat settles on the bunks it pivots back too far away from the crutch. I’m trying to move the hull 6-12 more inches to improve tongue weight. There’s something in the manual about towing to about 5 mph and slamming on the brakes which I tried unsuccessfully, and I read somewhere (manual?) about using an old tire as a bumper and backing up against a tree which I have not tried (too scared). As Peter suggested on my next attempt I will probably try pulling the trailer out incrementally and winching as I go. Seems kinda awkward.
>>>> Does anyone have any other tips?Also is it possible to buy too strong of a winch?AFAIK my winch is original (1986), but I did replace the strap!
>>>> Peter
>>>
>>
More information about the Rhodes22-list
mailing list