[Rhodes22-list] Trailer winch
Todd Tavares
tavares0947 at gmail.com
Thu Nov 19 08:23:10 EST 2026
I don't know if this figures into the equation but, at some point in time,
it appears the axles on the single axle trailers was repositioned 6" to the
rear.
Years ago I made a drawing and shared it on the list. I measured a of
couple trailers, and a few owners shared their measurements. I edited the
drawing to show the axle in the rearward most configuration. It should
still be in the Archives.
Todd T
On Thu, Nov 19, 2026, 12:29 AM Graham Stewart <graham at debgraham.ca> wrote:
> Chris: A picture of how this works would be really useful.
>
> > On Nov 18, 2026, at 8:57 PM, Chris Geankoplis <chrisgeankoplis at gmail.com>
> wrote:
> >
> > Keep in mind you should have between 350 and 450 pounds of tongue
> weight. That way she will tow beautifully on a single axel. You can use a
> 2x4 with 1’ in front of a fulcrum. So at the 4’ board math it will take
> about my weight of 175 to begin to lift the chocked trailer I work with a
> 6’ piece marked off at 4’3” (3” under the tongue and then 1’ to the
> fulcrum. Haven’t had any problems after towing well over 12,000 miles.
> > Chris Geankoplis
> > XENOS & Blue boat
> > Sent from my iPhone
> >
> >> On Nov 18, 2026, at 6:49 PM, Graham Stewart <graham at debgraham.ca>
> wrote:
> >>
> >> I have always found that I have been unable to to get the boat
> sufficiently forward. Ontario one occasion the boat started to sway
> severely. I was very lucky that it occurred on a multi lane highway when
> there was no traffic.
> >> I only tow the boat from my home to the boat launch about 5 miles at
> low speed so I am not concerned However, should I ever take it on a
> longer trip I would redistribute weight by moving the motor to the car and
> moving anything that is heavy like the gas tank forward in the boat.
> >>
> >>>> On Nov 18, 2026, at 11:24 AM, Mary Lou Troy via Rhodes22-list <
> rhodes22-list at rhodes22.org> wrote:
> >>>
> >>> It is awkward to pull it out incrementally but we were very
> successful doing it that way for the 18 years we owned the R22.
> >>>
> >>> Our method was to pull it forward until there was slack which if
> pulled further would allow the boat to slip back. At that point we paused
> and winched up the slack. We would do this however many times it took to
> get the boat to the right point. We had the bow stop piece marked with some
> paint so we knew exactly where we wanted to boat for the right tongue
> weight. We found that the process varied somewhat from ramp to ramp but we
> got so used to it that it only took a few minutes longer than if we had
> been able to winch it all the way forward.
> >>>
> >>> Mary Lou
> >>>
> >>>>> On 11/18/2026 10:34 AM, peter beckerman via Rhodes22-list wrote:
> >>>> Thanks to all for your thoughts, My recovery procedure: With
> the trailer in the water to the top of the bunks and the bow crutch slid
> all the way forward I winch the boat fully to the crutch. Then as I pull
> the trailer out of the water and the boat settles on the bunks it pivots
> back too far away from the crutch. I’m trying to move the hull 6-12 more
> inches to improve tongue weight. There’s something in the manual about
> towing to about 5 mph and slamming on the brakes which I tried
> unsuccessfully, and I read somewhere (manual?) about using an old tire as a
> bumper and backing up against a tree which I have not tried (too scared).
> As Peter suggested on my next attempt I will probably try pulling the
> trailer out incrementally and winching as I go. Seems kinda awkward.
> >>>> Does anyone have any other tips?Also is it possible to buy too strong
> of a winch?AFAIK my winch is original (1986), but I did replace the strap!
> >>>> Peter
> >>>
> >>
>
>
More information about the Rhodes22-list
mailing list